Senior Hardware Engineer

Omni Design Technologies is a leading provider of high-performance, ultra-low power IP cores, from 28nm down through advanced FinFET nodes, enabling differentiated system-on-chip (SoC) solutions. Our technology fuels innovation in critical applications ranging from 5G, wireline and optical communications, LiDAR, radar, automotive networking, AI, and image sensors. With a proven track record of exceeding 50% year-over-year growth, we are at an inflection point, poised to significantly expand our market share and solidify our position as a technology leader.

KEY RESPONSIBILITIES

Own test board development end-to-end: schematic capture, PCB layout review, BOM, bring-up, and debug

Design RF signal paths with careful attention to impedance matching, microstrip/stripline routing, connector selection, and launch structures for operation up to 64 GHz

Design low-noise power delivery networks using LDO regulators appropriate for sensitive analog and RF measurement environments

Characterize high-speed ADC and DAC devices including SNDR, SFDR, THD, and dynamic range measurements

Measure and interpret S-parameters to validate board signal integrity and RF performance across the full frequency range

Integrate FPGA or microcontroller subsystems on test boards to enable automated stimulus, data capture, and instrument control

Develop and maintain test automation scripts to streamline characterization workflows and regression testing

Work closely with analog and digital IC design engineers to define test requirements for each new silicon bring-up

Document board designs, test procedures, and characterization results clearly and thoroughly.

Qualifications

• Required

• B.S. or M.S. in Electrical Engineering or related field

• 5+ years of hands-on PCB design and hardware bring-up experience

• Demonstrated experience characterizing high-speed ADC or DAC devices

• Strong working knowledge of S-parameters and VNA measurement techniques

• RF PCB design experience including controlled impedance, grounding, shielding, and high-frequency connector and launch design

• Experience with low-noise LDO selection and power supply layout best practices for analog/RF environments

• Proficiency with schematic capture and PCB layout EDA tools of your choosing

• Hands-on proficiency with bench equipment: VNAs, spectrum analyzers, oscilloscopes, and signal generators

• Experience with JESD204B high-speed serial interface in an ADC/DAC evaluation context

• Desirable

• FPGA development experience — RTL design, embedded firmware, or board-level integration

• Python scripting for test automation, instrument control (VISA/PyVISA), and data analysis

• Prior experience designing or characterizing boards at mmWave frequencies (above 30 GHz)

• Familiarity with JESD204C or other emerging high-speed converter interface standards

• Experience in a fabless semiconductor or IC design environment

• KEY SKILLS AT A GLANCE

• PCB Design - Required · 5+ yrs

• Low-Noise LDO Design - Required

• Python Automation - Desirable

• ADC/DAC Characterization - Required

• JESD204B - Required

• mmWave (>30 GHz) - Desirable

• S-Parameters / VNA - Required

• Board Bring-Up & Debug - Required

• JESD204C - Desirable

• RF Design to 64 GHz - Required

• FPGA Development - Desirable

• MCU Integration - Desirable