BMS/EPMS Controls Technician III

Ability to own a task from beginning to end. Effectively communicating progress and/or issues about assigned task.

Can work both independently and as a part of a team.

Must be able to multi-task, it is very probable you will be assigned multiple tasks over multiple customers at any given time.

Basic proficiency in Microsoft suite (Word, Outlook, Visio, Excel, PowerPoint)

Can read schematics (network topologies, electrical one-lines, device wiring drawings, control drawings, etc...)

Familiarity with CAD, construction drawings

Strong understanding of open protocols (For Example... BACnet IP/BACnet MSTP/Modbus TCP/Modbus RTU)

Knowledge of terminating wire to terminal blocks to include RS-232, RS-485 and CAT 5/6

Troubleshooting skills, the ability to understand a problem and work toward reasonable solutions

Maintain proper understandings of code requirements for indoor and outdoor electrical infrastructure, and knowledge of handling higher voltage (120, 240, 480V) for controls purposes

Has had experience with BMS software, Tridium is preferred and understands wire sheet programming and logic.

Basic networking, ability to manipulate pc settings to access, set up and commission devices on a network.

Ability to visit job construction hard hat areas and climb stairs, climb ladders, maneuver in and around pipework and air ducts and work safely near exposed line voltage and low voltage wiring and terminations.

Possess valid state motor vehicle license and possess safe driving record as required by company’s insurance carrier.

Able to pass State and Federal security screening.

Out-of-state travel will be required (estimated to be up to 75%)

Understanding of Mechanical and Electrical equipment in a typical Data Center application